![]() If we haven’t listed your exact model or switch below try checking either the vendors support site or the this page: Cisco Switch Port Mirror guides:Ĭisco Nexus 7000 Switches: Juniper Switches Port Mirror guides: The configuration for setting up each of the switches will be slightly different based on the hardware and software version and specific Vendor. However some switch vendors may instead refer to this as a span port, network monitor, interface monitor or port monitor. At Packetloop the terminology we use for this setup is a port mirror. Most modern switches can be configured to send a copy of the traffic traversing this link and send it to another port to which you can connect your capture device (covered in another blog post link here). If you want to get started right now, the easiest option with least potential impact will be the port mirror on your Internet switch located between your Internet router and your firewall (you do have a firewall don’t you?). Do a traffic export from your router (not recommended).Use a port mirror (aka span port) configuration on your Internet switch.Well depending on your environment you are going to have a few options: How do I make a copy of the Network Data? ![]() If you know how to perform these two steps, then we expect to see you uploading shortly! If you don’t then read on.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |